熱門關鍵詞:
BS ISO 16232-8-2007 Road vehicles
  • 該文件為docx格式
  • 文件大小:120.22 KB
  • 下載次數
  • 文件評級
  • 更新時間:2020-03-30
  • 發 布 人Inventororor
  • 文件下載:
  • 立即下載

  • 文件介紹:
  • 該文件為 docx 格式,下載需要 10 積分
  • BS ISO 16232-8-2007 Road vehiclesNational foreword


    This British Standard was published by BSI. It is the UK implementation of
    ISO 16232-1:2007.
    The UK participation in its preparation was entrusted to Technical Committee
    MCE/22, Engines for road vehicles.

    A list of organizations represented on this committee can be obtained on request to its secretary.
    This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application.
    Compliance with a British Standard cannot confer immunity from legal obligations.











































    This British Standard was published under the authority of the Standards Policy and Strategy Committee
    on 29 June 2007


    © BSI 2007




    ISBN 978 0 580 50921 6

    Amendments issued since publication



    INTERNATIONAL STANDARD

    ISO
    16232-8




    First edition
    2007-06-01













    Road vehicles — Cleanliness of components of fluid circuits —

    Part 8:
    Particle nature determination by microscopic analysis

    Véhicules routiers — Propreté des composants des circuits de fluide — Partie 8: Détermination de la nature des particules par analyse
    microscopique


































    Reference number
    ISO 16232-8:2007(E)









    Contents Page


    Foreword............................................................................................................................................................ iv

    Introduction ........................................................................................................................................................ v

    1 Scope.....................................................................................................................................................1

    2 Normative references...........................................................................................................................1

    3 Terms and definitions...........................................................................................................................2

    4 Principles...............................................................................................................................................2

    5 Equipment.............................................................................................................................................2

    5.1 General...................................................................................................................................................2

    5.2 Analysis equipment..............................................................................................................................3

    5.3 Environmental conditions....................................................................................................................4

    5.4 Health and Safety..................................................................................................................................4

    6 Calibration.............................................................................................................................................5

    7 Procedure..............................................................................................................................................5

    7.1 General...................................................................................................................................................5

    7.2 Element analysis procedure................................................................................................................5

    8 Expression of results...........................................................................................................................6


    Annex A (informative) Example of classifying particles according to their chemical composition........7








    Foreword


    ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

    International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.

    The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote....
文檔留言
驗證碼: 請在右側輸入驗證碼 看不清楚,換一個
河北20选5走势图